新闻资讯
固溶处理对热压成型CoCrW合金组织及力学性能的影响
发布人：上海艾荔艾金属材料有限公司www.shailiai.com
更新时间：2015-12-01
利用SEM, XRD 和TEM 等分析手段研究了固溶处理对热压烧结CoCrW合金相组成的影响, 通过硬度测试、室温拉伸和摩擦磨损实验, 研究了固溶处理对热压烧结CoCrW合金力学性能的影响.
固溶处理对热压成型CoCrW合金组织及力学性能的影响EFFECT OF SOLID SOLUTION TREATMENT ON MICROSTRUCTURE AND MECHANICAL PROPERTIES OF HOT-PRESSED CoCrW ALLOYS
利用SEM, XRD 和TEM 等分析手段研究了固溶处理对热压烧结CoCrW合金相组成的影响, 通过硬度测试、室温拉伸和摩擦磨损实验, 研究了固溶处理对热压烧结CoCrW合金力学性能的影响. 结果表明, 热压态与固溶态CoCrW合金的组成相均为M23C6, M6C, CrCo金属间化合物和γ-Co基体; 固溶处理降低了合金中的 M23C6含量、原始颗粒边界, 同时改善了合金塑性和耐磨性能. 合金室温硬度、抗拉强度均随固溶温度升高、固溶时间延长而先增高后降低.
Co-based alloy has high strength, good corrosion and wear resistance, and is widely used in aviation industry, nuclear industry. The cast Co-based alloys has high hardness brittleness, but the toughness is low, which limits its widely use. The CoCrW alloy prepared by powder metallurgy process has high toughness, at the same time, the mechanical properties of the CoCrW alloy can be changed by heat treatment. In this work, the effect of solid solution treatment on the microstructure and mechanical properties of the hot pressed alloy was studied by SEM, XRD and TEM, hardness test, room-temperature tensile and wear experiment. The results show that the microstructure of the as-hot pressed and solid solution state CoCrW alloy are both composed of M23C6, M6C, CrCo intermetallic compound and γ-Co matrix, the contents of M23C6 and prior particle boundaries decrease remarkably after solution treatment, meanwhile, the toughness and wear resistance of the alloy are improved. With the increase of solid solution temperature and time, the hardness and tensile strength at room temperature of CoCrW alloys increase first and then decrease.
前一页：Ti-6Al-7Nb生物医用钛合金高温变形机制的研究
后一页：440C不锈钢