新闻资讯
热轧TC21板材中α相形貌的演变
发布人：上海艾荔艾金属材料有限公司www.shailiai.com
更新时间：2015-11-02
研究了具有片层α组织TC21钛合金在β和α+β相区热轧制后的组织演变规律及其片层组织的球化机制。
热轧TC21板材中α相形貌的演变Evolution of α phase morphology in hot-rolling TC21 titanium alloy plate
研究了具有片层α组织TC21钛合金在β和α+β相区热轧制后的组织演变规律及其片层组织的球化机制。结果表明：变形温度及应变对具有片层α组织的TC21钛合金断裂及球化具有显著影响。当变形温度为990℃时，在β相区发生变形；当应变不小于0.51时，平行轧向和晶界附近的片层α组织首先发生断裂、球化，晶内片层α组织被压弯变形；当在接近相变点(即950 ℃)变形，应变达到0.92时，片层α组织发生球化；当在两相区较低温度，即910 ℃和870 ℃变形时，片层α取向杂乱，且被压弯成“手风琴”状，未发现球化。TEM观察分析发现，具有α片层组织的TC21钛合金球化过程是一个复杂过程，首先，通过动态回复或是晶界滑移使得α片层中形成α/α界面；然后，β相通过亚晶界楔入α片层，α片层解体；最后，通过物质末端迁移，发生球化。
The microstructure evolution and mechanisms of globularization of TC21 titanium alloy with lamellar structure were investigated during hot rolling in the β phase and α+β phase. The results show that the prominent effect of hot working parameters on the break-up and globularization of TC21 titanium alloy with lamellar structure is found. The α lamellar structure along the paralleling rolling orientation and adjacent grain boundaries is broken up and globularized and the intragranular α lamellar is buckled and kinked when TC21 titanium alloy is processed in β phase region (990℃) at strain no less than 0.51 and at 950 ℃ and strain 0.92. When TC21 titanium alloy is deformed at 910 ℃ and 870 ℃, α lamellar is buckled and kinked to become accordion. Then, by TEM analysis, it is found that the mechanism of globularization of TC21 titanium alloy with α lamellar is a comprehensive process that is firstly the formation of α/α interface by dynamic recovery or boundary splitting, secondly the disintegrating of α lamellar due to diffusing, and finally the globularization of α lamellar by termination migration.
以上资料由上海艾荔艾金属材料有限公司提供，欢迎新老客户来电洽购。
本文来自上海艾荔艾金属材料有限公司http://www.shailiai.com，转载请注明出处。