新闻资讯
Sm对AZ91D合金显微组织与力学性能的影响
发布人：上海艾荔艾金属材料有限公司www.shailiai.com
更新时间：2015-10-31
利用光学显微镜、扫描电子显微镜和X射线衍射仪分析铸态和固溶态AZ91D-xSm(x=0~1)合金的组织和相组成，测试其室温拉伸力学性能和冲击韧性。
Sm对AZ91D合金显微组织与力学性能的影响Effects of Sm on microstructure and mechanical property of AZ91D alloy
利用光学显微镜、扫描电子显微镜和X射线衍射仪分析铸态和固溶态AZ91D-xSm(x=0~1)合金的组织和相组成，测试其室温拉伸力学性能和冲击韧性。结果表明：随着Sm含量的增加，铸态组织中不连续网状β-Mg17Al12相发生破碎，数量逐渐减少，而小块状高热稳定性新相Al2Sm数量逐渐增多；拉伸力学性能和冲击韧性整体均逐渐提高，AZ91D-0.88Sm合金的抗拉强度σb、伸长率δ和冲击韧性αnK分别达到230 MPa、15.5%和24 J/cm2；经固溶处理后，β-Mg17Al12相完全固溶于α-Mg基体中，只存在Al2Sm相；拉伸力学性能和冲击韧性均明显提高，但其提高幅度随着Sm含量的增加而有所减缓。
The microstructures and phase compositions of as-cast and solution-treatedAZ91D-xSm (x=0-1) alloys were investigated by optical microscopy, scanning electron microscopy andX-ray diffractometry. Meanwhile, the tensile mechanical property and impact toughness at ambient temperature were tested. The results show that the discontinuous networkβ-Mg17Al12phase breaks and decreases gradually among the as-cast microstructure with increasing the Sm content. Meanwhile, small block Al2Sm new phase with high thermal stabilityincreases gradually.The tensile mechanical property and impact toughness on the whole are enhanced gradually. Tensile strength σb, elongation δand impact toughness αnKof AZ91D-0.88Sm alloy reach230 MPa, 15.5% and 24 J/cm2, respectively. After solution treatment, β-Mg17Al12phase dissolves into α-Mg matrix completely and Al2Sm phase still exists. The tensile mechanical property and impact toughness are enhanced obviously and the improving amplitude decreases slightly with increasing the Sm content.
以上资料由上海艾荔艾金属材料有限公司提供，欢迎新老客户来电洽购。
本文来自上海艾荔艾金属材料有限公司http://www.shailiai.com，转载请注明出处。