新闻资讯
多组织因素对GH4738合金裂纹扩展速率的交互影响
发布人：上海艾荔艾金属材料有限公司www.shailiai.com
更新时间：2015-10-26
提出了一种可以综合反映多组织因素对GH4738合金疲劳裂纹扩展速率影响的多组织因素交互影响方程，并利用不同的热处理制度设计了具有不同组织特征的试样。测定了经不同热处理制度后GH4738合金在650℃下的疲劳裂纹扩展速率。利用该方程分析了GH4738合金晶粒尺寸、碳化物及γ＇相对疲劳裂纹扩展速率的影响。
多组织因素对GH4738合金裂纹扩展速率的交互影响INFLUENCE OF MULTI-MICROSTRUCTURE INTERACTION ON FATIGUE CRACK GROWTH RATE OF GH4738 ALLOY
提出了一种可以综合反映多组织因素对GH4738 合金疲劳裂纹扩展速率影响的多组织因素交互影响方程，并利用不同的热处理制度设计了具有不同组织特征的试样。测定了经不同热处理制度后GH4738 合金在650℃下的疲劳裂纹扩展速率。利用该方程分析了GH4738合金晶粒尺寸、碳化物及γ＇相对疲劳裂纹扩展速率的影响。结果表明，多组织因素交互影响方程能很好地定量描述各组织因素对GH4738合金疲劳裂纹扩展速率的影响及其综合影响。增大晶粒尺寸、降低γ＇相及碳化物尺寸均可降低 GH4738合金疲劳裂纹扩展速率，并且晶粒尺寸对 GH4738合金的裂纹扩展速率的影响程度要高于 γ＇相尺寸及碳化物。
The effects of microstructure on the fatigue crack growth behavior of hard-to-deformed GH4738 superalloy have been studied by a number of researchers. But most of these studies are confined to a single factor, such as the effect of grain size on the fatigue crack growth rate. The studies only show the effect of single factor which do not reflect the combined impacts of multi- microstructure factors. There is a need to develop quantitative approach to predict the effects of multi-microstructure on fatigue crack growth behavior in the high damage-tolerant microstructure design of GH4738 alloy. Therefore, A new multi-microstructure factors interaction equation is proposed for the prediction of the effects of grain size、γ＇size and carbide size on fatigue crack growth rate of GH4738 alloy in this paper. Different microstructures of GH4738 alloys are produced by different heat treatments (HT) for this equation. The fatigue crack growth experiments are carried out under constant stress ranges on compact tension (CT) specimens at 650℃ in air. It then analyzed the effects of grain size, gamma prime size and grain boundary carbides size on the fatigue crack growth rate of GH4738 alloy by using the multi-microstructure factors interaction equation. The results show that the equation can well predict the fatigue crack growth rate of GH4738 alloy under different microstructure. Increasing grain size and reducing γ’ size, carbides size can decrease the fatigue crack growth rate of GH438. The impact of grain size on fatigue crack growth rate is more noticeable than that of γ’ and carbide size.
以上资料由上海艾荔艾金属材料有限公司提供，欢迎新老客户来电洽购。
本文来自上海艾荔艾金属材料有限公司http://www.shailiai.com，转载请注明出处。