新闻资讯
流变压铸A380铝合金的显微组织与力学性能
发布人：上海艾荔艾金属材料有限公司www.shailiai.com
更新时间：2015-09-15
将自主研发的强制对流搅拌制浆装置(FCM)与压铸机结合，以汽车控制臂为例，成功实现A380铝合金的流变压铸成形。研究FCM工艺参数下铸件组织特征的演变，对比传统压铸与FCM流变压铸工艺下铸件显微组织、内部缺陷和力学性能的差异，分析FCM流变压铸工艺组织形成机理及其凝固行为。
流变压铸A380铝合金的显微组织与力学性能Microstructures and mechanical properties of A380 aluminum alloy produced by rheo-diecasting process
将自主研发的强制对流搅拌制浆装置(FCM)与压铸机结合，以汽车控制臂为例，成功实现A380铝合金的流变压铸成形。研究FCM工艺参数下铸件组织特征的演变，对比传统压铸与FCM流变压铸工艺下铸件显微组织、内部缺陷和力学性能的差异，分析FCM流变压铸工艺组织形成机理及其凝固行为。结果表明：适当提高螺杆转速或降低内筒温度，均有利于改善铸件的组织形态；FCM流变压铸工艺不仅可以获得内部组织细小、圆整且分布均匀的铸件，而且可以显著减少铸件内部气孔缺陷和提高铸件的力学性能。和传统压铸件相比，FCM流变压铸件的抗拉强度、屈服强度和伸长率分别提高了10%、4%和140%。
Taking auto control arms for example, the rheo-diecasting process of A380 alloy was obtained by combing a self-developed forced convection mixing rheoforming machine (FCM) with a diecasting machine. The microstructural characteristics of FCM rheo-diecasting parts in various processing parameters were investigated. The differences of microstructures, internal defects and mechanical properties in traditional diecasting parts and rheo-diecasting parts were compared. The formation mechanism and solidification behavior of semisolid slurry were analyzed in FCM rheo-diecasting process. The results show that raising rotation speed or decreasing barrel temperature appropriately is beneficial to optimize the microstructure of rheo-diecasting parts. The process not only can get parts with fine, spherical and uniformly distributed primary α(Al) particles, but also is able to increase mechanical properties and decrease pore defects of parts evidently. Compared with traditional diecasting, the tensile strength, yield strength and elongation of FCM rheo-diecasting parts are increased by 10%, 4% and 140%, respectively.
以上资料由上海艾荔艾金属材料有限公司提供，欢迎新老客户来电洽购。
本文来自上海艾荔艾金属材料有限公司http://www.shailiai.com，转载请注明出处。