新闻资讯
β固溶处理对TC21合金组织性能的影响
发布人:上海艾荔艾金属材料有限公司www.shailiai.com
更新时间:2015-09-11
对等轴组织TC21合金进行β相区高温固溶+α/β相区低温固溶+低温时效热处理;分析β相区高温固溶冷却速率、α/β相区低温固溶温度对TC21合金组织和性能的影响。
β固溶处理对TC21合金组织性能的影响Effect of β solution treatment on morphology and mechanical properties of TC21 alloy
对等轴组织TC21合金进行β相区高温固溶+α/β相区低温固溶+低温时效热处理;分析β相区高温固溶冷却速率、α/β相区低温固溶温度对TC21合金组织和性能的影响。结果表明:随着β相区固溶冷却速率的增加,α/β相区固溶热处理后合金中条状α相尺寸明显减小,α条厚度减小;随着α/β区固溶处理温度的降低,在相同的β相区固溶冷却速率下,合金中的初生条状初生α相尺寸有一定的减小,相含量增加。经过(960 °C, 1 h, FC)+ (890 °C, 1 h, AC)+(620 °C, 6 h, AC)三重热处理后,TC21合金的强度、塑性和韧性匹配较好。这表明三重热处理可以改善常规锻造TC21合金的综合力学性能。
The equiaxed TC21 alloy samples were β solution treated, followed by α/β solution treatment and then aged at low temperature. The effect of β heat treatment cooling rate and temperature of α/β heat treatment on the morphology of TC21 alloy was analyzed. The results show that higher cooling rate of β heat treatment leads to the shrinking of platelet α phase, in the α/β heat treatment process. It is also confirmed that lower α/β heat treatment temperature, after the same beta heat treatment process, results in the decrease of width and increase of the content of platelet α phase. After optimized triplex heat treatment (960 °C, 1 h, FC)+(890 °C, 1 h, AC)+(620 °C, 6 h, AC), the strength, plasticity and fracture toughness match well, indicating that the triplex heat treatment can improve the synthetical mechanical properties of TC21 alloy.
以上资料由上海艾荔艾金属材料有限公司提供,欢迎新老客户来电洽购。
本文来自上海艾荔艾金属材料有限公司http://www.shailiai.com,转载请注明出处。