新闻资讯
热处理对Ti46Al4Nb1Cr0.2B合金相和等温热压缩行为的影响
发布人：上海艾荔艾金属材料有限公司www.shailiai.com
更新时间：2015-09-09
通过改变TiAl合金的相分布，实现在低温区对TiAl合金的热加工。TiAl合金经过不同热处理过程得到不同的相分布，随后在共析温度下对合金进行等温压缩，观察应力和组织变化，利用退火消除变形组织。
热处理对Ti46Αl4Nb1Cr0.2B合金相和等温热压缩行为的影响Effects of heat treatment on phase and isothermal compression behavior of Ti46Αl4Nb1Cr0.2B alloy
通过改变TiAl合金的相分布，实现在低温区对TiAl合金的热加工。TiAl合金经过不同热处理过程得到不同的相分布，随后在共析温度下对合金进行等温压缩，观察应力和组织变化，利用退火消除变形组织。经6 ℃/min升温，在1 340 ℃保温15 min，并空冷处理后的合金和经12 ℃/min升温，在1 340 ℃保温15 min，并空冷处理后的合金的最大应力比合金铸锭的小，而且试件没有开裂。在α相转变温度附近对等温压缩后的合金进行退火，合金的变形组织消失，而在再结晶温度附近进行退火的合金的变形组织没有完全消失。相的分布可以影响TiΑl合金在低温区的热加工性能，而完全消除变形组织应在α相转变温度附近进行退火。
Hot workability of TiAl alloys at low temperatures was improved by changing the phase distribution of TiAl alloys. The alloys were compressed below eutectoid temperature and annealed. The stress and microstructure were observed by scanning electron microscope. TiAl alloy has different phase distributions after different heat treatments. The maximum stress of ingot is higher than that of alloy which has been heated with cooling rate of 6 ℃/min and treated in 1 340 ℃ for 15 min and finally cooled in air to RT as well as alloy which has been heated with cooling rate of 12 ℃/min and treated in 1 340 ℃ for 15 minutes and cooled to RT during isothermal compression process. The crack is not observed in these alloys. The deformation microstructure of alloy disappears after annealing near α phase transition temperature and can be observed after annealing near the recrystallization temperature. The phase distribution affects hot workability of alloy at low temperatures and the annealing near α phase transition temperature completely eliminates the deformation microstructure.
以上资料由上海艾荔艾金属材料有限公司提供，欢迎新老客户来电洽购。
本文来自上海艾荔艾金属材料有限公司http://www.shailiai.com，转载请注明出处。