新闻资讯
5A90铝锂合金超塑变形的不均匀性及其对空洞演化的影响
发布人：上海艾荔艾金属材料有限公司www.shailiai.com
更新时间：2015-08-22
在475 ℃、初始应变速率为3×10-4~1×10-3 s-1的变形条件下对5A90铝锂合金试样进行拉伸，研究合金超塑变形的应变分布以及其对空洞演化的影响。
5A90铝锂合金超塑变形的不均匀性及其对空洞演化的影响Inhomogeneity of 5A90 Al-Li alloy during superplastic
deformation and its effect on evolution of cavity
在475 ℃、初始应变速率为3×10-4~1×10-3
s-1的变形条件下对5A90铝锂合金试样进行拉伸，研究合金超塑变形的应变分布以及其对空洞演化的影响。结果表明：合金超塑变形是不均匀的，应变和空洞沿着拉伸方向呈梯度分布。应变量、空洞的尺寸与体积分数由肩部到断口逐渐增大。在不同的应变速率条件下，空洞的长大机制不同。在较高的应变速率(1×10-3
s-1)条件下，空洞以塑性控制长大为主。降低应变速率至8×10-4
s-1以下时，空洞以扩散长大机制为主。而在同一局部应变区域，横截面与纵截面空洞长大机制也不同，横截面空洞呈球状，为扩散控制的长大机制；纵截面空洞呈不规则状，且沿拉伸方向被拉长，为塑性控制的长大机制。
The local strain distribution during superplastic
deformation of 5A90 Al-Li alloy and its effect on the evolution of cavity were
studied through uniaxial tension at constant temperature of 475 ℃ and different
initial strain rates of 3×10-4-1×10-3 s-1. The
results demonstrate that the deformation of alloy is inhomogeneity, the strain
and cavity remains non-uniform throughout the gauge. The strain, cavity size and
volume fraction were found to increase from the shoulder section to the fracture
tip. The cavity growth is different under different initial strain rates. In the
case of high strain rate (1×10-3 s-1), the cavity growth
is controlled by plastic deformation, and reducing the strain rate to
8×10-4 s-1, the cavity growth is controlled by diffusional
process. And in the region with same local strain, the cavity growth mechanism
in longitudinal section is different from transverse section. The transverse
section with spherical is controlled by diffusional process cavity, while the
same longitudinal section with elongated cavity is controlled by plastic
deformation.
以上资料由上海艾荔艾金属材料有限公司提供，欢迎新老客户来电洽购。
本文来自上海艾荔艾金属材料有限公司http://www.shailiai.com，转载请注明出处。